The conventional manual call point designed for conventional fire alarm system for reporting fire or emergency condition by pressing its breakable glass. The manual call point can be test by a test key without breaking the glass.eatures and Benefits Compatible with all the conventional fire alarm control panel Can be reset by key 470 Ohm resistance Easy surface mounting Base included
 |
Operating Voltage Range: 24 VDC Volts
Alarm Current 10 to 30 mA @ 24 VDC
Operating Humidity Range: 10% to 93% Relative Humidity, Non-condensing
Operating Temperature Range: -10°C to 50°C (14°F to 122°F)
Input terminal Wire Gauge: 12 to 18 AWG
Dimensions: Length 88mm, Width 88mm, Depth 50mm
Weight: Net Weight 172g, Gross Weight 185g
Alarm Current 10 to 30 mA @ 24 VDC
Operating Humidity Range: 10% to 93% Relative Humidity, Non-condensing
Operating Temperature Range: -10°C to 50°C (14°F to 122°F)
Input terminal Wire Gauge: 12 to 18 AWG
Dimensions: Length 88mm, Width 88mm, Depth 50mm
Weight: Net Weight 172g, Gross Weight 185g
Loop Design and Wiring The fire alarm control panel Zone wire can be connected to terminal 2(+),4(-). And there is a 5.1V Zener diode should be connected to terminal 1A and 4A.(included by default). If the manual call point is in the end of the zone wire, a 5.6K resistance should be connected to terminal 2, 4. INSTALLATION NOTE: All wiring must conform to applicable local codes, ordinances, and regulations. Mounting Indoor Wall 1. Attach mounting base to wall at 1.5 meter's high. 2. Connect field wiring to terminals 3. To attach product to mounting base. 4. Secure product by tightening the one mounting screws in the front of the product housing. Figure 1. Install and Wiring diagram:  |